genuinesilikon.blogg.se - Set up a wansview w3 on ip cam pro

#SET UP A WANSVIEW W3 ON IP CAM PRO MANUAL#
#SET UP A WANSVIEW W3 ON IP CAM PRO PC#

add camera shortcuts to your home screen (IP Cameras, MultiView or Snapshots).

Add MJPEG or JPEG Stream (also webcams are supported).

data usage for each camera, traffic overall and last session, display data rate per second.

Switch on and off the LEDs for network activity or IR LEDs (if supported).

MultiView, watch 4 or 8 cameras simultaneously (4 = landscape, 8 = portrait), by scrolling you can see up to 96 cameras, tab on the camera to switch to control mode.

Mirror videoimage horizontally or vertically, for cameras hang headover.

Setup resolution, frames per second (fps), brightness and contrast.

control also in fullscreen mode (landscape).

Turn the iPhone for fullscreen mode, with fully control ability.

Optical zoom (only for compatible cameras), digital zoom (pinch to zoom) also for cameras without a optical zoom function.

Schedule can be set (for standard MJPEG IP cameras).

Option for automatic saving of images on alarm (only for standard MJPEG IP cameras).

Option for automatic driving to a preset on alarm (only for standard MJPEG IP cameras).

Setup motion detection (internal, external): automatic email delivery, email management, setting the internal motion sensitivity, optical and acoustic alarm, activate FTP upload with setting the upload interval.

Auto patrol settings (horizontal, vertical, horizontal + vertival), setup the interval and rounds of each interval.

#SET UP A WANSVIEW W3 ON IP CAM PRO MANUAL#

Setting the speed for manual or automatic control (Pan-Tilt Speed).Presets, camera positions, load and save up to 16 presets.http or secure https connection to your camera (if supported by your camera).Access over local network (LAN, WLAN) or over internet / WAN IP / DDNS Host (mobile data 3G, 4G).All functions and controls are integrated in a intuitive and visually attractive interface.įeatures (please note: not all functions are supported for each camera) So you can easily check up your cameras or use them as baby monitors. Take access to your cameras over your home network or over the internet.

#SET UP A WANSVIEW W3 ON IP CAM PRO PC#

On a different PC (one that’s not connected to the same network as your camera), you can view your camera by opening the web browser, typing address):(Camera port number) and pressing Enter.With ipCam FC you can control your IP cameras on the iPhone & iPad or make settings. Go to Status page to check the WAN IP address of the router. For the Protocol, we recommend you select ALL. Type the IP address and the port used by the camera in the corresponding field. Go to Forwarding > Virtual Servers and click Add New. Log into your router’s management page (). For this example, we are using a TP-Link TL-WR941ND. Consult your router’s technical support accordingly. The configuration depends on the router model. You can do that by going to SETTING > BASIC > System > Initialize and clicking Reboot.Īfter you reboot, log back into the camera on your web browser, usingĪfter this, you’ll need to adjust the port forwarding settings on your router. In the image below, we changed it to 3333.Īfter you change the port, you will need to reboot the camera in order to save the changes. However some ISPs block port 80, so you may need to change the port number accordingly. Usually there is no need to change the port number. Go to SETTING > BASIC > Network > Information to find the HTTP port number used by the camera. Open a web browser and type the IP address. If you don’t know its IP address, click here. HTTP://192.168.1.101 represents the IP address of the camera being accessed.įind your camera’s IP address. Note: The steps below assume you already have your IP camera installed and connected to a router with Internet access.